Questions & Answers for: fuser temp - Page 9

...the paper, yours has a blown heat lamp or a faulty temp sensor (thermister) This area is not for playing in cause it is a electrical and fire hazard, just have new fuser fitted and error will be

toner and the drum together in one unit. The fuser is where it warns "high temp! do not touch!" Just buy another printer or use the backup printer. Again, this is NOT something you can fix by yourself

...temp. While I had the fuser apart I found one small resistor attached to the frame directly under the main drive gear. I did an ohms test on the resistor and it showed bad. I really hate to tear my ...

...fuser never reached its desired temp to come to ready. Could be a bad thermostat or thermistor. Check fuser for any debris or excessive gunk build-up and clean what you can. The error can be cleared ...

...temp causes E002 appear. 4)check any paper roll over the surface of fixing roller.try to remove it. 5)fixing roller or fuser roller located near to printing output. fuser needs repalcing fussier lamp ...

...fuser temp) Sir, this error usually ocurs when you towner is empty or have completed is age.But as you said error fuser temp this might be that you priner buffer has got damaged while it repaire able ...

...fuser temp error dont no why? Cant print oh its a big problem.fusing temperature error means that either the thermostat or thermister is open in fuser unit. only a Ricoh technician can check it and ...

fuser unit temp there is a reset switch it is under by the interlock swith you should be able to reset it if it keeps coming up you will need to replace parts on the fuser unit it is an issue with low

...Fuser Temp'' SER. NO.: 0L001037 RATING: 220 - 240V, 50/60Hz, 4.5A In the laser printer fuser one or two temperature controllers of the fuser rollers.These are ...

...'enter'. Turn machine off to exit Maintenance mode. C6000 indicates fuser did not come up to temp in the allotted time; you 'may' have a bad heater lamp if code reappears. Good luck.........