Questions & Answers for: upper knife - Page 3

Upper Knife My machine quit cutting so I replaced the blade and it still does not cut. It does not appear to sit low enough to meet the bottom blade. I am getting very frustrated. any ideas? Thanks ...

the upper knife is not cutting and I just bought the knife maybe putting on wrong sometimes you can disengage the cutter so maybe you've accidently turned that knob ?

...upper knife in the non-working position on the euro-pro serger 101-548? You push it with your thumb on the black screw thats holding the knife in place - might be a bit stuck at first (mine

knife two inches from the left corner of the dryer.Slide the blade over the retaining clip, and raise the top panel completely back toward the rear wall. 4.Disconnect the door switch wiring harness on

...upper knife to the highest position.Clear the stitch fingers.Push the stitch with former release lever and remove the stitch former from the lower knife base. (Don't lose it!)Turn the stitch with ...

...upper knife out of adjustment. It is so high now that it even at it's lowest point it no longer reaches the lower knife far enough to cut and of course raising the lower knife does not allow ...

my overlocker is not cutting it is a mylock434 I have changed the upper knife but still not working. Could be the lower knife.

...upper knife now wont cut. Do I need to replace the knife? more than likely as the knife blade would have been damaged and blunted Are you saying the knife still functions but it is not cutting the ...

...upper knife can be lifted, but that is usually for the purpose of cleaning or threading. HOWEVER, it is recommended to never use the serger without the knives. What frequently happens is the fabric ...

Knife Overlock Blade - Upper and Lower Amazon.ca https://www.amazon.ca > ... 2pc Set Serger Knife Overlock Blade - Upper and Lower - Brother 925D 929D ... Return policy: Eligible for Return, Refund or