I overtightened my oil drain bolt and put a small crack in the bottom of the case my bike is in the 07 KTM 450sxf with the rf4 motor in it what should I do @
Drain oil. Use degreaser to clean area. Use JB Weld & allow to set up properly before adding oil.
If you’ve found this helpful, please click the green “helpful” icon. If you have 20 seconds please leave a few words as a review or recommendation! Also, follow me for more answers to everyday issues, I’m all for saving you money and making the most of your time! Thanks and have a great day!
SOURCE: 2007 ktm 450sxf electric start issues
i would check the main fuse first then i would check the charge in the battery the shorted charger may have discharged the battery or killed some of the cells
SOURCE: Lenovo y510
Hi,
This is the known issue with the Y 510 so please contact to the customer care and get it replaced.
SOURCE: 07 ktm 450sxf wont start
take your carb out, clean the entire thing, that means every nook in that *****. do this and if still a problem write back because in most cases were n idiot is involved, this is the most over looked problem
SOURCE: crack in my yz 125 2001 crank case
You know aluminum can be welded very successfully now, so best bet is to remove that case and take it in to a good welder..You can ry the quick fix (JB Weld) is what i recommend, but success is rare !....good luck to you my friend...Tim
SOURCE: KX60 2001,losing oil from crank casing and won't start.
hi mate take it to a descent welder who can weld aluminium and when welded fill it back up with light gear oil and also the bike will start with no oil but if ran too long the gearbox will seize and will cost you a engine rebuild normally 300 pounds ++ so get it sorted asap good luck
247 views
Usually answered in minutes!
×