I have a mpi monitor 2400, and the e13 code is always showing up. what does this mean? how do i fix it?
You have an obstruction in your fuel line. Lint or rust or some other debris, either in your main fuel filter which I hope you have or in the small one in the fuel sump on the lower right hand side (the little square hole below the round finger hole for the reset button). The screen is cleanable with air or brakekleen or both. Or it might be that your Constant Level Valve is tripping or has tripped. Push the button in the round hole on the lower right hand one time quickly (don't hold it down or press it several times slowly) and you should hear the float drop. Fuel should resume flowing to the fuel sump at that time.
10,216 views
Usually answered in minutes!
Did you ever get an answer.
So i had the E13 code come up on my 2400 i replaced the filter yes there was water but its to late buy that time put new filter in and bam E13 so i took the line off the burner( small copper line behind face plate) i turned it back on and waited till it started dripping dripping fuel after that i turned power off took ine off pump hooked it back to burner and blew through it hooked it all back up and turned it on fuxed it and put the face back on HOPE THIS HELPS
×