Machine filled with water and "h20" appeared on the machine then water leaked out of the machine.Emptied the machine then the error code "F13" appeared
Plug off the wall. There is a thin rubber tube going from the switch area to the exit near the outlet tube. Probably this is blocked. This tube should be free from any blockage; take out the top clip from this tube and blow into it - it should be free, clear the blockage if any and refit. This is the water level tube which tells the machine when to switch off water, etc.....
3,076 views
Usually answered in minutes!
i have a hotpointwt761 with h20error code that is a warning that water is not geting through but my washer just keeps on filling till it over flows help
the rubber ring has come off the front entrance and the machine is showing a water leak fault. i have emptied the machine and refastened rubber ring, but fault signal keeps flashing
how do i get rid of fault signal
Will not fill with water and run. Electrical panel lights up and appears to be operating. No error messages appear
Getting an F13 error fault at the end of the cycle, what should I do?
New machine. First time use. Model WL4227P1 96207. Fills with water, beeps, stops, code 1 12
Error. Code 32 appears. I select a programme and switch it code. The was he dryer clicks twice then nothing
×