The error is related to the Transfer belt mark detection, which means that there a mark on the transfer belt and a sensor to detect the mark to make sure that the belt is turning around.
The problem could be if the sensor is dirty, the belt is dirty, belt is out of position or damaged(torn), or worst case, the motor is bad.
SOURCE: sc481 What does this code mean?
Hi,
This Code refers to Transfer Belt Mark Detection Error.The Information that i found on the Outer World ( Internet ) is that the Main Motor is Operating and the Lock Signal is Detected. The Belt Mark Sensor Signal does not change for 120 milliseconds.
Possible Causes
1. Defective Main Motor
2. Image Transfer Belt Out of Position
3. Belt Mark Blurred or Absent.
I have a Diagram as well collected from that Forum for you :-
Let me know, if needed further assistance.
Hope i helped you.
Thanks for using ' Fixya ' and have a nice day!!
270 views
Usually answered in minutes!
×