Trustworthy Expert Solutions

At Fixya.com, our trusted experts are meticulously vetted and possess extensive experience in their respective fields. Backed by a community of knowledgeable professionals, our platform ensures that the solutions provided are thoroughly researched and validated.

View Our Top Experts

Cutter Problem I have a 1055cm plus with multi-roll feeder. The plotter began making what can best be called a rattling noise when cutting yesterday. Since the noise began the cuts have been getting a little ragged. Not necessarily torn but definately not clean either. This morning during a print job the carriage stopped after a cut and the plotter displayed the error "Turn printer off and check print path." When checking the path I discovered a black rubber washer approx 3in in diameter wedged beneath the carriage underneath the black print head. I'm unable to determine where the washer came from, and the cutter continues to rattle. Any advice?

1 Answer

steve shroder

HP Expert 141 Answers
Posted on Sep 09, 2008

steve shroder

HP Expert

Joined: Aug 07, 2008

Answers

141

Questions

Helped

62793

Points

244

The cutter has that bushing attached to act as a tire as it travels across the scan axis, these infrequently wear out and cause the carriage to basically drag the blade behind causing your uneven cut pattern, the cutter must be replaced. If you need direction on how to do so please contact me