How do I delete an Aqualink RS4 program? The filter is on all the time. When I set a new program start and stop time the controller keeps adding programs versus replacing an/the existing programs.

SOURCE: Need to clear a program from my aqualink

Start with the cancel button. It will then prompt you to cancel the desired program. Go through the menu as you would with a program but follow the prompts to cancel. Remember, press cancel to start.

SOURCE: I need to clear a

Start with the cancel button and follow the prompts

SOURCE: I have an Aqualink RS4. I want to delete the 3

The best thing to do is to clear the system memory. Aqualink can have a problem with "ghosting" Things just go on by themself when not programed to. A bad spa side remote can do that to but that is another problem.
To clear the memory
Push the menu button once
Push the back arrow to "System setup"
Push star * or enter button
Push back arrow till diplay says " clear memory "
Push star or enter
Push star or enter again to comfrim.
You will get a message "earsing memeory"
Now you can reprogram system
If you want differant run times like a summer and winter timing you can do that with the program groups

Hope this helped
Keith

SOURCE: Jet blower randomly starts ...

most of the time this is caused by a faulty spa side controller. If you trace the line from the spa and disconnect it see if that solves the problem.

SOURCE: pool lights go on randomly--not programmed to go on at all

make sure the light is pluged in a port that is for like a spare aux. any time you add programs you must hit the store button.