same problem on MAH8700 front loader. replaced control board and still doesn't work. ordering new motor. hope it will fix it.same problem on MAH8700 front loader. replaced control board and still doesn't work. ordering new motor. hope it will fix it.
My motor went out first. Bad winding visible (it is a 2 speed motor, so it is possible for it to work in low speed, and not in high)
Now the 3E is back with a vengeance. Sometimes 3-4 times per load, sometimes not at all.
The conventional wisdom says that the control board is not getting tach info from the motor. The Hall Effect sensor is inside the motor, so I have replaced it already. There is a service bulliten on the harness, says to look for a pin pushed back in the connector. Mine is fine. I will probably go to a new style connector that isn't as cheap, then move on to replacing the control board.
It is just 3 years old. What a piece of ****. My motor went out first. Bad winding visible (it is a 2 speed motor, so it is possible for it to work in low speed, and not in high)
Now the 3E is back with a vengeance. Sometimes 3-4 times per load, sometimes not at all.
The conventional wisdom says that the control board is not getting tach info from the motor. The Hall Effect sensor is inside the motor, so I have replaced it already. There is a service bulliten on the harness, says to look for a pin pushed back in the connector. Mine is fine. I will probably go to a new style connector that isn't as cheap, then move on to replacing the control board.
It is just 3 years old. What a piece of ****.
You can't post conmments that contain an email address.
- If you need clarification, ask it in the comment box above.
- Better answers use proper spelling and grammar.
- Provide details, support with references or personal experience.
Tell us some more! Your answer needs to include more details to help people.You can't post answers that contain an email address.Please enter a valid email address.The email address entered is already associated to an account.Login to postPlease use English characters only.
Tip: The max point reward for answering a question is 15.
same problem on MAH8700 front loader. replaced control board and still doesn't work. ordering new motor. hope it will fix it.
My motor went out first. Bad winding visible (it is a 2 speed motor, so it is possible for it to work in low speed, and not in high)
Now the 3E is back with a vengeance. Sometimes 3-4 times per load, sometimes not at all.
The conventional wisdom says that the control board is not getting tach info from the motor. The Hall Effect sensor is inside the motor, so I have replaced it already. There is a service bulliten on the harness, says to look for a pin pushed back in the connector. Mine is fine.
I will probably go to a new style connector that isn't as cheap, then move on to replacing the control board.
It is just 3 years old. What a piece of ****.
×