Questions & Answers for: Kohler break flush Computers & Internet

How do you get the top plastic cap off the Kohler Ingenium flush tower without breaking it? I need to adjust the flow as the toilet runs constantly and the water level is way to high. My Kohler ...

...break the bottom of the bowl where the valve seat is located.) Then install the new foam gasket on the assembly. The new assembly is replaced in the reverse manner. I removed the new flapper from the ...

...Flush Valve Kit in Santa Rosa model ONE PIECE toilet? The plastic stand-pipe/flapper valve assembly has three prongs at the circular base at 120 deg. apart. It is not flexible and I do not want to ...

...for a short time then reverts back to little to no pressure. We replaced hot water heater which was breaking down at the core and putting a white crystal like subatance in the lines. We have cleaned ...

messing with the bolts. If on is too lose you can tighten it, but if you try to loosen one you risk breaking the seal between the tank and the bowl

...flush down the toilet paper, i have to physically break it down with a stick for it to go down. what can i clear in the cistern to strengthen the water flow again had any work done recently, if so if ...

...the # 5 because I don't remember. I think it will but they were haveing trouble with the older one breaking down due to chlorine and other water treatment chemicals.I Thank

...flapper will seat and make a seal. If this does not work and the flapper is visibly detioriated and breaking down shut off the water supply, remove the toilet flapper and visit your local plumbing ...

...in securing toilet to flange Hopefully you can tighten it Sometimes the flange bends up or can break. Many a flange is not held down properly with good enough screws or the plywood has been ...

flush buttons with the float mechanism. This aligns tabs on the button mechanism with a slot on the mating surface allowing you to 'pop' the button assembly off with the help of a screwdriver. It will