Questions & Answers for: BITS collets routers Computers & Internet

i have to cut a slot to insert a low voltage wire. I have to cut a slot to insert a low voltage wire. Is the router the way to go. 50 foot run. I have to remove the baseboard so this is right at ...

I have a DR1 (100 series) and plugged it in to a speed control module. It sputtered afew seconds then stopped working. ... it most likely damaged the brushes and armature in the motor. some units are ...

rotozip dr1 internal schematic diagram where do the 2 copper clips attach to the on/off switch ? The second one goes near the cord and holds the tool in place.

where do the 2 copper clips attach to the on/off switch internally The second copper clip is installed near the cord entry point and holds the tool in place.

I was using the cutoff wheel to cut 5/8 bolts in half on about the third bolt the rotozip stopped. It will not even by hand. I suspect the load was too heavy. Reset button? Could it be a fuse or reset

I have a B&D Router KW850E. It has collars and collet nut to take bits with 1/4 inch and 5/16th's shank. Can I get a collet nut and collar for 12mm or 1/2 inch? probably not as the shanks of the ...