Questions & Answers for: Sharp component burn Computers & Internet

...possibility that the power amplifier burned (too low a load at too high an output). The burnt component then represents a failure. When you try and power on the unit, it will go to its built-in ...

...Called the cable company to troubleshoot the cable box. It is fine. Any suggestions. is there a component that has burned out? I doubt that your component has burned out. You may be looking at a ...

...turn it on and smoke comes out the vent. What could it be? The fan motor or some other electrical component. Either way I would quit using it until it gets fixed as an A/C unit is cheaper than a ...

...use. Is the smell ionized (the outside smell of a cold winter morning air) or more of an electronic component burning??? if it's more of an ionized smell it could be normal, (if the smell is ...

...in Check its fuse at the power supply board.  If found burned, make sure that there is shorted component/s.  Try to repair it.  If the repair cost exceed than the cost of a new one, ...

...the capacitor. Also verify that the door closes properly and that the circuit board has no burned components or burned circuit traces. Sometimes the relays stick and need replacing but that would ...

The timer counts down but the microwave does not come on We put stuff in to be heated and set the time. The timer starts counting down but the microwave does not come on to heat it up. Then you have ...

...oven smoke and strong burning plastic smell in microwave oven Burning plastic, not food? A component has overheated badly then, with a plastic case. The main suspect would be the high

...exceeds designed specs, as a safety feature, the power supply will shut down. Usually a failing component in the TV is the cause here. 2. Excessive heat build up in the switchmode power supply, ...

resistor is located on the power supply board, you may do a trouble shutting to replaced the burned components, or replace the whole board