Questions & Answers for: Honda insert pause Computers & Internet

...insert a paper clip into both prongs will read your code for you. This is done by counting the flashes of your check engine light. It will flash for different lengths of time long then short (ex. 4 ...

...insert the 2 ends of the clip into the connector to 'jump' it. Turn the ignition switch to the on position (don't start the vehicle), and the check engine light will flash. Count the flashes, short ...

insert the paper into BOTH holes in the plug in. you are essentialy going to complete the circuit. with the paper clip inserted, turn your keyall of the way on (DO NOT START THE CAR. IT MAY DAMAGE THE

...them to verify that it is the correct radio for you vin. You only get three attempts to insert code. Disconnect battery, wait 20 minutes, then apply code. Push buttons fully and pause. Hope this ...

...insert a paper clip so that it connects the two holes. Then, if you turn your ignition to ON II (do not start the car) the D4 light will blink out a code, using both long and short blinks. The blinks ...

insert honda OBD1 diagnostic jumper (or as FSM directs) engage Diag mode. then crank engine for 5 seconds. then release key, does the ECU flash out codes for a failure.,, BINGO all cars work like this

insert a paperclip across the 2 wires. Then turn on the key and count the flashes using the CHECK ENGINE light which doest he same flashes as the computer LED whenever the paperclip is connected. They