Questions & Answers for: Karcher needle attach float Home

Question about 2500 PSI Pressure Washer

1 Answer

...any gas, but gas comes all the way thru the fuel line. it will start up for like 5 seconds and then die. any suggestions? Remove and clean the carburator. Sound line a stuck needle on the

Ad

Question about 2500 PSI Pressure Washer

2 Answers

...same problem. Patio cleaner head worked fine until a few minutes ago. Detached the head and poked a needle through the two spinning jets without removing them. The centre bar for the spinning jets is ...

Ad

Question about 2500 PSI Pressure Washer

1 Answer

...Float and needle making sure to get the pivot / hinge pin installed correctly and reinstall the silver retaining screw. g. Fuel selector ON. Raise and lower float checking for free movement with fuel ...

Question about 2500 PSI Pressure Washer

2 Answers

...load a Honda Engine manual! Thank you ! Will it run if you pour a small amount of gas in the carb? If so, sounds the the float needle is stuck closed. Pull and clean/replace the carb.needle and

Question about G3025OH Pressure Washer

1 Answer

float is a needle (small pin like) that should shut the fuel off & let it run also. Turn the fuel back on,the fuel should be running out quickly. Push the float up and the fuel should stop running

Question about 2500 PSI Pressure Washer

1 Answer

...a spray paint can lid in around 10 seconds. If you do not have this kind of fuel flow.. investigate from the float needle back to the fuel tank outlet for restricions. Thanks for choosing FixYa, ...

Question about 2500 PSI Pressure Washer

1 Answer

float will drop and the needle valve will fall out. Then you will have to remove the entire carburetor to put back together. Once you get the bolt out you will have to clean the holes in the bolt this

Question about KE302007A Classic Series Pressure Washer for 230 Volt/ 60 Hz

1 Answer

...the area in squiggly lines Squiggly lines are sign of nozzles being partially clogged. Try using a needle to clear nozzles. You will need to remove the nozzles to do this. When re-installing the ...

Question about 2500 PSI Pressure Washer

2 Answers

...float and needle jet passages.Be sure to remove all plastic and rubber parts before using the laquer thinner because it can dissolve the plastic parts and render them unuseable.Be sure to use ...

float needle is mis aligned with the needles seat or theres a object or deris the seat stopping it fully closing off the fuel flow cheak thease the float may also damaged and filling up with fuel this

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...