Questions & Answers for: OKI pairing sheet Computers & Internet

okidata ml390/391 Turbo When printing continuous feed labels I can't figure out (after reading the entire user guide 5x) how to print a sheet of labels and have the next label line up. Ie., I print ...

oki microline 590 elite when i print a job sheet the next sheet doesn't line up so i can print again, i can only print 1 at a time. i have to tear,tear the sheet off, tear again and manually line the ...

Okidata ML320 feeding blank sheets We have a Okidata ML320 used for printing continuous forms. We are using the rear feed, page length is 11". We have it hooked up as a parrallel printer. We are ...

OKI Microline 320 When it starts printing on the left side shows "a" on sheet on left side of sheet of blank paper. Its the 1st or 2nd line. I think it must means aligned. What do I need to do to ...

I had one sheet jam. I pulled it out and a corner I had one sheet jam. I pulled it out and a corner tore off and I don't know how to get to that corner. Switch off. Open all access panels. Need a good

how to install paper in oki microline 320 turbo printer Paper Loading Rear Feed, Continuous Forms Use the rear-feed path for printing on single-thickness, continuous-form paper. Use the single-sheet ...

FALLS OUT OF alignedment ON THE SECOND PAGE CONTINUES TO GO UP AFTER EACH PAGE do you use tractor paper or plain sheets, if tractor and rear feed gear is engaged and sensor does not see that it is and

What would cause tray 1 to misfeed every 12 to 15 sheets? The misfed sheet ends up laying on the edge of the paper tray advanced about 3/8" from the paper stack? I have cleaned the three small gray ...

Why is my printer only printing a black sheet of paper? I have changed the toner 2 times and still only print black on the sheet Hi it is not the toner but it could be a developing unit or transfer ...

My oki c3400n continual paper jam's at the fuser. Paper comes out of the printer about 2 inches then jam's. I clear it and it happens again. Don't see any contamination on the fuser roller. There are ...