Questions & Answers for: Rainbow rainbird controller Computers & Internet

"New" Rainbow Eseries flashing red light I noticed a red flashing light inside the vacuum right under the on/off/purify control - it looks like a filter. The light only flashes red when the vacuum is ...

rainbird sprinkler system one station sets off alarm on controller and wont run'' Ususally means you have a bad solenoid on the valve. Find the valve, disconnect solenoid and run system. If no error ...

E2 gold series - makes loud noise on start up Rainbow E2 gold series - makes loud "screeching" sound for 2-4 seconds on start up. Is this normal? That is normal. All E2 two speed Rainbows make that ...

rainbow e2 2 speed vacuum shuts off after 5 minutes of vacuuming. Hi. We have a rainbow e2 2 speed vacuum. Recently, our vacuum motor has been turning itself off after about 5 minutes of vacuuming our

my rainbow vacuum will not start in high speed but runs in low speed i checked the switch with an ohm meter and the switch appears to work. is the controller board the next suspect? i removed it and ...

vacuum e series works on low but not on high rainbow e series It is either the switch or the controller. Call us and we can see if it is still covered under your warranty. RainVac www.rainvac.com

Looking for replacement component for motor controller board, a capacitor that is in series with the AC input line. E2-Series rainbow vacuum, motor controller board. Unfortunately Rainbow does not ...

rainbow e2 type 12 120v , accidentally plugged into 220v, would barely power up, possibly controller board defective? bought the rainbow vacuum e2 type 12 unit from the U.S. and brought it home to the

Rainbow controler I plugged an 110v rainbow into a 220v plug. It started but after 3 seconds it stopped. I opened the controler and it had a spot before the CIPOS that got burned, the rest look ...

rainbow vacuum does not turn on to vacuum ,only circulate air Check the manual control located at the handle hose if it fully open it only circulate air .....slowly close it to desired power of the ...