Question about GLEH1642DS Front Load Stacked Washer/Dryer
...apart. 2 men 2 hrs minimum tub halves are bolted together and entire assembly will need to be removed bearing is not a service part entire rear shell will need replacing and probably basket
Torque specs for outer shell screws tighten till snug run with load ckd for leaks retighten if necessary can be don with top removed and from bottom
...shell and basket come out to do this repair....what bad bearing and rusted shaft looked like... Picture1 - Picture2 - Picture3 I had to remove the back panel. Undo the pump hose & water level hose, ...
Question about GLTF1670A Front Load Washer
...shell/bearing assembly (part # 131525500). To do this, practically the whole machine will need to come apart. To remove the drive pulley, remove rear cabinet panel. Remove the pulley screw and pull ...
Question about GLTF1670A Front Load Washer
...shell and basket come out to do this repair....what bad bearing and rusted shaft looked like... Picture1 - Picture2 - Picture3 I had to remove the back panel. Undo the pump hose & water level hose, ...
...of rear upper corners. Slightly pull the front panel forward about 1/2" to disengage clips. Remove the shell. Thanks for using FixYa - a 4 THUMBS rating is appreciated for answering your FREE ...
something metal is between my basket and shell. It makes a bad rubbing noise. How do I get it out? I can't see how to get the front off. Try removing a paddle from the basket and getting to it that ...
...remove it from the window,from it`s shell,and take it out side and wash it out,be careful not to bend over the fins on the evaporator,and the condenser with the water hose.If this does not help,then ...
...Remove the back panel to inspect the counter weight, spider pulley and belt. If the counter weight is not broken you can reattach it to tub shell and retighten the bolts. If it is broke it is about ...
I need to repair a freon line on a FFHT2126LS. It is near the front of the unit under the shell of the refrigerator. How can I remove the shell to access the line? get a new machine!!!!!!!!!!!!!!!!!
Usually answered in minutes!
