Questions & Answers for: Seagate sata raid controllers Computers & Internet

SATA RAID BIOS setup there appears a notice: ?The number of disks is not adequate to create a RAID!!!? What does this mean? I don?t have enough knowledge with SATA/RAID, Is my SATA disk corrupted? How

...SATA) and loaded Windows XP on that along with 3d max , etc, software applications. Just after 24 hours, when I restarted the system, the OS crashed and even I lost the partitions also, means all my ...

Hi. my computer crashed a long time ago and I had to order some recovery disks but before I run them I want to backup the files on the drive but it has something called RAID (both 320GB hard drives ...

a new seagate sata Some older mainboards only allow you to use SATA after you have declared your disk through the raid utility. Watch out when you do so that you select the right configuration (Raid 0

...raid process. This also depends slightly on the OS If it was a harware failure that required a motherboard or new server chassis then you could drop the drives in after installation of a new primary ...

...SATA controller is set to "NON RAID" mode in bios. You need to go into BIOS to change these settings, If you don't know how to do it Give me your motherboard details (model no makers name)and I'll ...

...setup program." 2x Seagate Barracuda 7200.9 500gb in a raid config. You must first press f6 to load the SATA drivers for the hard drive before you go forward with the install. Good Luck, NOLA ...

I just experienced my third ST3500418AS failure in 3 months. My disks are in RAID10 (1+0) configuration, so I've just been returning the drives, and the RAID rebuilds, but what's going on? I ...

SATA RAID interface needs to be compatible with SATA revision V2.0. Check the drives with the Seagate diagnostic tool (download it from Seagate) for correct operation. This will also check / test 

Is a mpc clientpo 414 all in one a raid system just wondering if it is a raid system I have a Seagate barracuda 250 gb hard drive I want to use in it and it says not to do a firmware upgrade to the ...