Questions & Answers for: IBM set up raid 1 Computers & Internet

raid drivers when setup starts...then set will ask you to insert the floppy containing the files...It will ask you when you get to the same screen that tells you no harddrive found....The raid drivers

s just needed to set the boot order correctly in the bios menu. For me, it worked. Now, I got an adaptec 7T sata raid controller, and I have both SCSI raid and Sata raid together  (320GB + 1Tera)

...set up the RAID config. Then on the Blue screen of Windows installation it will say "press f3 for 3rd party drivers", hit F3 (I think its F3), then insert a floppy disk with the drivers for you RAID ...

...Raid set on the server. The system will run fine with one failed drive, but it is recommended to have the drive replaced by it's vendor, or vendor representative. If the 2nd drive in your raid set ...

...RAID disks, and verify them, but when I boot into windows repair program and try and load the SATA drivers it just hangs. Any thoughts on how I can troubleshoot and isolate this problem. Did you try ...

...RAID Array is set as bootable and I cannot find any reference to the array in the BIOS setup. A few questions: 1. Is this a new (clean) install? If so, have you installed the drivers for the RAID ...

...make a factory default before.. (set it to the factory settings first and after that remove the achi or raid settings ..and save with F10 ) ..and will work .try it and let me know how it worked

...Raid card but it does not work properly i cant set mirroring options, I use two different size hdd. any one to help my problem Regards P.Jana janabsc@yahoo.com send me you querry clearly to my email ...

...ServeRAID-7k show me 4 disk "Defunct". In mini-configuration menu i choose "Restore to factoruy settings" and disks drops to "RDY". But my RAID not rebuild. Pls help, what should i do? When you ...

raid is there, set bios to boot to raid. my servers here better are Dell R710 and boot to sdd and have 8 drive RAID extra. raid 6 me. to support any server one needs to know who it was all setup day1.