Questions & Answers for: Asrock setting up raid 1 Computers & Internet

Motherboard does not have a SATA configuration on bios setup My motherboard have sata connectors but only shows the IDE ports on the IDE configurations on the bios setup, so i am not able to set up my

...RAID setting in the BIOS. Here is a copy and paste from the manual: If you want to install Windows 2000 or Windows XP on your SATA HDDs, you will need to make an SATA driver diskette before you start ...

...it should be the ONLY DVD or CD on your system.) use your arrow buttons to move around in the bios settings. you can always exit without saving and leave your system the way it was.*S* But once you ...

sound card when I set up K7S8X setup goes up to 94% then stops and note emerges that the comp can't find cmuda.sys. Ana ends. Please provide more info as does this happen when your installing OS ...

update bios systemsoft mobilepro bios ver1.01 for sis - the laptop can't boot from cd xp your bios is not updated properly. try again. make sure there is no power problem while updating. update bios ...

...And; http://www.pctechguide.com/tutorials/RAID.htm Motherboards that support RAID will have a bios setting that will need to be enabled. The links above will help you setup an array. Cheers' ...

new build Asrock N68-S UCC. System boots successfully from firmware DOS(?). BIOS shows that HD and SATA DVD drive recognized. Boot sequence set up for boot from DVD drive as device 1. Drive's read ...

...it on it says mac address are invalid in both cmos and flash. what do i do? configured the BIOS settings yet? Make sure your set the RAM to run as Supports DDR400/333/266 non-ECC, un-buffered ...

I ran win 7 setup in windows vista because it won't run at boot up, I have the disk in my samsung sata dvd drive and it doen't give me the prompt to boot from cd even though I have the dvd set as ...

...raid device as im useing windows xp! once thats done i press enter as instructed by the onscreen promts and windows starts.. now i get a message that i should check connections of the device and ...