Questions & Answers for: IBM setting up raid 1 Computers & Internet

ibm x series 226 attempt to install os and says no harddrive IBM x series 226...attempt to install OS and it says no harddrive installed. I am very new to this server.. Make sure that the motherboard ...

Boot problem with IBM xseries 206 - SCSI Drive and SATA drive I have a server with windows 2k server installed in a HDD SCSI, but When a SATA drive is attached for data storage purpose, the system not

when i install MS windows server 2003 in IBM x3400 server it gives me message that setup could not find any hard desk installed in your computer. guys please help me temor Ensure drives are seated ...

ServerRAID-6i Logical drv =1, Others=0 Firmware7.12.13,Status OK Warning:1 Logical drive(s) Offline Warning:1 Online drive(s) defunct HI, It appears you may have a failed "physical" drive in your Raid

I recently installed Win7 on IBM intellistation zPro (6223), with RAID 1 SATA drives. All worked well for a few days, but then system would not boot. I can go into bios and see the RAID disks, and ...

I am trying to install SBS 2011 (Win Server 2008 R2 OS) on an IBM x3400. I have created a Raid 1 (mirrored) array. When partitioning the RAID to install we get the message "Windows cannot be ...

setting feature too .. Just select it ..and let it run in compatible mode or non raid . or disable achi ..or sata as ide or  native .. depending on the BIOS edition it may refer to the same thing

Raid Driver Dear All I want to know about Raid 0-1, I put one Raid card but it does not work properly i cant set mirroring options, I use two different size hdd. any one to help my ...

...setting you have reset the RAID configuration & probably lost all the data You are not supposed to reset Raid Controller as it may delete present raid configuration. What you can do is 1: Insert ...

RAID-5, RAID-6, RAID-10, and RAID-50 available . no server can boot after the COIN died, due to all settings in BIOS are lost. and we open the case se what is there, if raid is there, set bios to boot