2
Anonymous posted an answer for this 2001 Jeep Grand Cherokee:
"no, you have to ck each wire where it goes."
Anonymous
Anonymous posted an answer for this 1986 Jeep CJ7:
"The linkage could be binding or broken."
AnonymousAnonymous posted an answer for this 1988 Jeep Cherokee:
"Check the map sensor on the firewall and make sure the vacuum line is not broken."
AnonymousAnonymous posted an answer for this 1988 Jeep Cherokee:
"You didn't change the rod you changed the switch. The switch on the column should be..."
AnonymousAnonymous posted an answer for this 1995 Jeep Cherokee 2 Door:
"Since the car stall only in the drive position, it sounds(i'm not there to actually ck the..."
Anonymous
Anonymous posted an answer for this 2005 Jeep Grand Cherokee:
"I would bypass the alarm and see if it cures the problem."
Anonymous
Anonymous posted an answer for this 2002 Jeep Grand Cherokee:
"If I remember there is a circuit breaker for the windows in the fuse panel, also ck the..."
Anonymous
Anonymous posted an answer for this 1994 Jeep Grand Cherokee:
"That is probably a casting hole-no importance"
AnonymousAnonymous posted an answer for this 1994 Jeep Grand Cherokee:
"The overdrive unit is mechanical"
AnonymousAnonymous posted an answer for this 1994 Jeep Grand Cherokee:
"Have you tried the crank sensor on the trns. bell housing. If the sensor does not work, it..."
Anonymous
Anonymous posted an answer for this 1990 Jeep Wrangler:
"You have to go to the Jeep dealer and they can take it apart and install new brass..."
Anonymous
Anonymous posted an answer for this 1992 Jeep Wrangler:
"ck the map sensor"
AnonymousAnonymous posted an answer for this 2005 Jeep Grand Cherokee:
"They did have problems with the disk and radio.Jeep has an updated disk(it happened to my..."
Anonymous
Anonymous posted an answer for this 1995 Jeep Wrangler:
"ck the condition of the tranny fluid. If the fluid is very dark, it will need changing...."
Anonymous
Anonymous posted an answer for this 1999 Jeep Grand Cherokee:
"Hit the shifter on the top with a good hit to push it down, sometimes the "T" handle will..."
AnonymousAnonymous posted an answer for this 2002 Jeep Grand Cherokee:
"Check your fuses."
Anonymous
Anonymous posted an answer for this 2004 Jeep Grand Cherokee:
"Check condition of the tranny fluid it should be pink. Bring the jeep to a muffler place..."
Anonymous
Anonymous posted an answer for this 1996 Jeep Grand Cherokee:
"If the jeep is all wheel drive, it's 4wd all the time with some slippage done through the..."
Anonymous
Anonymous posted an answer for this 1995 Jeep Grand Cherokee:
"There is no programing for the locks to work only with the door closed. Look at the..."
Anonymous
Anonymous posted an answer for this 1998 Jeep Cherokee:
"Check the wiring harness between the "A" pillar and drivers door. The harness usually..."
Anonymous
Anonymous posted an answer for this 1991 Jeep Wrangler:
"Check the brake switch on the brake pedal for your brake light prob. There are 2 wires on..."
AnonymousAnonymous posted an answer for this 1996 Jeep Grand Cherokee:
"If the Jeep is making noise when the oil pressure is low, what you might be hearing is the..."
AnonymousAnonymous posted an answer for this 1998 Jeep Cherokee:
"It's possible the clock spring in the steering column is bad. That would have to be looked..."
AnonymousAnonymous posted an answer for this 2001 Jeep Grand Cherokee:
"The resistor is screwed into the heater housing under the dash on the pass. side. If you..."
Anonymous
Anonymous posted an answer for this 1995 Jeep Cherokee:
"Steering wheel has to come off and airbag disconnected (by a qualified tech or it can blow..."
AnonymousAnonymous posted an answer for this 1995 Jeep Cherokee:
"A good bump will make that jeep shimmy real bad If the steering damper is bad. If the..."
AnonymousAnonymous posted an answer for this 2001 Jeep Grand Cherokee:
"There is a sensor on the radiator that controls a relay to turn the fan on. There is also..."
AnonymousAnonymous posted an answer for this 1999 Jeep Cherokee 4WD:
"This is an electrical problem. There is a harness that runs in back of the cylinder head...."
AnonymousAnonymous posted an answer for this 1999 Jeep Cherokee 4WD:
"How is this car running? Remove the vacuum line from the pressure regulator on the fuel..."
AnonymousAnonymous posted an answer for this 1999 Jeep Cherokee 4WD:
"The speed sensor gives a reference to the cpu and from there an output to the speedo head...."
Anonymous
Anonymous posted an answer for this 1997 Chrysler Concorde:
"You need to go to the dealer and buy a new arm. Sometimes some local part stores will have..."
Anonymous
Cars & Trucks 472 answers
Computers & Internet 1 answer
