Questions & Answers for: command 86 - Page 3

...boot from your xp disk and choose R to get into the repair console. Once there type the following commands fixboot fixmbr then try the install again. Hope this ...

...86-based computers. convert dynamic [noerr] Use the convert dynamic command to change a basic disk into a dynamic disk. The disk may contain valid data partitions. convert basic [noerr] Use the ...

How do I convert between the rectangular and polar form of a number with imaginary values? i.e. I want to take the number a+bi and convert it to polar D<(angle) and vice versa. Use the >Rec ...

86 IF CLICKS RELAY GOOD. IF RELAY GETTING POWER GOOD AND THE 30 AMP COOLING FAN FUSE OKAY.EITHER THERE IS A SHORT IN COOLING FAN WIRING OR THE PCM HAS FAILED.THE PCM HAS LOST OR COMMAND RUN CIRCUIT IN

...86.    Ignition ON, command the AIR Pump Relay ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states.    ...

Has power, will not crank. Turn key to start, one click will not turn over Open the fuse panel under the hood and find the starter relay, marked on lid. Remove the relay and look at the bottom for ...

...86 and the control circuit terminal 85. Command the Low Beams ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states. ?‡' If the test lamp is ...

...86. Command the Low Beams ON and OFF with a scan tool. The test lamp should turn ON and OFF when changing between the commanded states. ? If the test lamp is always ON, test the control circuit for a ...

...86 in the low speed relay socket. You should see battery voltage. With the AC on and engine running, check for ground on terminal 85. If you're not getting ground the next question is: is the front ...

86 and the ignition circuit terminal 85. Command the affected relay ON with a scan tool. Verify the scan tool Relay Control Ckt Short Volts Test Status Parameter is Fault. ? If not the specified value