BMC Sidewinder Lowrider Softail - Popular Questions, Answers, Tips & Manuals - Page 3
Cleaned my carburetors and the Jets and now my bike won't start. I have a spark but it won't start.
All questions need FULL 'year make model', as the first 3 words.
Then there are 10,000 categories listed by 'make year model'.
So we are working blind.
Make sure gasoline is being delivered to the carbs by removing the fuel delivery pipe.
Carbs come in different systems. If it has a float bowl on the bottom, tap it with the handle of a screwdriver as it may be stuck.
Turn the engine over. If it doesn't start, remove the spark plug and see if it is wet with gas?
You need three things for an engine to start
Clean gas
A spark at the right time
Compression
You have one thing missing
//
2/21/2024 5:36:50 PM •
Motorcycles
•
41 views • 0 helpful votes
Were do the fuel lines go to on a mountop 150cc
This particular unit has a typical GY6-style engine with a fuel line designated from the gas tank to the carburetor distinguished by an in-line cylindrical fuel filter located near the center of the line. Best to locate the carburetor distinguished by the location of the air filter, there should be a hose going from that unit up into the gas tank.
Ideally, remove the gas tank entirely and it should reveal the gasoline lines directly to the carburetor.
The photo shows the fuel line/filter indicated in red, and the location of the carburetor within the blue indicator.
2/27/2024 7:07:40 PM •
Motorcycles
•
36 views • 0 helpful votes
How do I reset 2007 Victory Vegas 8 ball petrol sensor please.
To reset you need to follow this steps below
1.Turn the ignition switch to the "On"position
2.press and hold the trip reset button on the dashboard until the fuel gauge reset or blinks
3.Release the trip reset button
4.Start the engine and let it run for a few minutes to allow the sensor to recalibrate
5.Turn the engine off and then restart it to ensure the reset was successful
2/8/2024 3:04:00 AM •
Motorcycles
•
37 views • 0 helpful votes
How can I get my E bike to run 28 MPH versus the default speed?
Tip #3: Swap your motorYou'll simply want to source a motor that has a higher KV or RPM rating than your current motor. For example, if you have a 48V e-bike that travels at about 20 mph (32 km/h), you can swap on this hub motor and reach speeds closer to 28-30 mph (45-48 km/h).
Aug 1, 2018
..
1/8/2024 9:31:26 PM •
Motorcycles
•
40 views • 0 helpful votes
How to remove filter and clean it?
Year Make Model of the motorcycle please?
Please always include that information as first three words. Then they are thousands of motorcycle categories listed by;
make year model = Suzuki 2003 GSXR1100
If it is the foam type filter, put Dawn Dish Detergent on it, wash out the dirt, dust and oil. Keep squeezing under running water until the water runs clean. Leave to dry. Then spray it with Oil Filter Oil and replace the filter. For paper filters, just replace them if they look dirty.
99-0516 K&N Air Filter Oil - 12.25oz - Aerosol
K&N
https://www.knfilters.ca > 99-0516-air-filter-oil-12-25...
K&N 99-0516 is a 12.25 ounce aerosol can of air filter oil. K&N Air Filter Oil is the only oil specially formulated to work in combination with the cotton ...
US$15.99 · In stock
..
12/12/2023 10:57:17 PM •
Motorcycles
•
43 views • 0 helpful votes
Not finding what you are looking for?
