Top 20 General Water Pump Pulley, cog belt, large C-AEA476 Questions & Answers

Question edited for clarity. Question moved from Cars and Trucks, because it isn't. help in the link, plus access to the maker. https://www.google.com/search?q=gp+t+series+47+ts1321+schematic+diagram ..

for what model?

just remove the tip and spray it out but i think its the black tip there will be very low pressure while using this tip then swap tip to rinse

Hi,
Take the four bolts out that hold the motor to the pump body...then carefully so that you do not ruin the gasket, get the motor the impeller and the pump face plate off of the pump body...it may take a bit or prying and tapping to get it apart...
Then comes the fun part...the impeller spins off of the motor shaft in the opposite direction of the rotation of the motor...so check the motor rotation and then you have to spin the impeller off of the motor shaft...a strap wrench works sometimes and sometimes you need to beat the impeller with a hammer and screw driver to get it off... holding the motor shaft at the same time can be a problem...sometimes you can get to the shaft and other motors have a screw driver slot or a nut at the back ot the motor to allow you to hold the shaft...this is best done with two people...

Once the impeller is off then the plate can slide off of the shaft... however you should replace the ceramic seal with a new one when installing a new motor...usually the old seal will leak if you do not... of course if you do not install the new seal very carefully it will leak also...
then place the plate on the new motor and spin the impeller on again....

For me... I usually always but a motor, impeller and seal when doing a job like this...

Good luck!!

heatman101

Did you ever get an answer on this? I have a similar model with a similar problem and can't get an answer anywhere?

their is 2 plugs one that goes into the other than that gets plugged in, unplug both , and only plug in the one cable with the prongs. the float on the pump is not working.

Please see the attached link, this may aid you.

http://www.1728.com/flowrate.htm

I hope this may have helped,
Tom

If your pump is turning then something is stopping the water from being removed. If you can see the pump check to see if the water is becoming turbulent when the pump kicks on? If the water doesn't appear to move or is moving only a little then either the pump impeller is damaged or the screen that keeps debris from entering the pump is clogged.
If it's never been cleaned it is most likely just a clogged filter screen. Clean it and it should work fine. If however the screen is clear then it is either a blocked line or a bad pump. And yes a pump can still run and not pump, if the impeller is bad.

You can download the Intermatic pdf file on installation and operation of your product.

http://www.intermatic.com/images/instruction_sheets/158ej11853.pdf

DONT KNOW WHAT KIND OF MOTOR THIS IS BUT : IF THE MOTOR SAYS 115/230 VOLT AC ON THE INFO TAG AND IT HAS A LOW/ HIGH WIRING DIAGRAGM THEN YOU SHOULD BE ABLE TO CONVERT IT. SOME MOTORS HAVE A SWITCH ON THE FRONT FACE WHERE YOU REMOVE A SCREW AND ROTATE A SHAFT. IF THIS DOESNT HELP GIVE MORE INFO. JODY

Question edited for clarity.Question moved from Misc category to Plumbing.It depends were the leak is, but you don't tell us? Holes in pipes, leak where it goes to a tap.https://www.google.com/search?q=repair+my+leaking+water+pipe..

Question edited for clarity.Question moved from Misc category to make model.Puzzled with the reference to bathroom sinks? Are you using this groundwater sump pump to pump fresh water to your sink?New Pump is $368New Check Valve is $79 to $100 depending on type.Check Valvehttps://zoellerpumps.com/product-category/accessories-parts/check-valve/M53 Pumphttps://www.google.com/search?q=Zoeller+Effluent%2F+Sump%2F+Dewatering+Sump+Pump+Model+M53..

Check the water seal directly behind the pan.

not a car, but water pump. it must be primed first books says The Smarthead is a compact, non-adjustable electronic device that automatically controlls the operation of the pump. it replaces a pressure tank, pressure switch, and float switch. With a smarthead, if your water tank runs dry, the pump will shut off immediately. The Smarthead includes the following features: it says self priming but gee I bet the water tank is higher (level) grade than the pump to do that. or 1st google hit https://vextrini.blogspot.com/2010/07/water-pump-with-smart-head-not-coming.html

I would try their dealer; Lowes https://www.lowes.com/pd/Utilitech-2-HP-Cast-Iron-Lawn-Pump/3087295

Matco Norca, Graff, Sayco/Briggs and Hain-Yo JL02BJ https://www.google.com/search?q=valve+jl02bj ..

Question edited for correct spelling of maker 'Noen' to 'Moen'. 'Fix' as in it is leaking? Or tighten it down because it is wobbly, or something completely different?

Moen One-handle Replacement Cartridge -- 1225

MOEN https://www.moen.com > products > Moen > 1225 From finishes that are guaranteed to last a lifetime, to faucets that perfectly balance your water pressure, Moen sets the standard for exceptional beauty ... "); background-repeat: repeat-x; display: inline-block; overflow: hidden; position: relative; background-size: 14px 11.4px; height: 11.4px; width: 68px;">"); background-repeat: repeat-x; display: block; background-size: 14px 11.4px; height: 11.4px; width: calc(62px);"> Rating: 4.4 · ‎ 31 reviews · ‎ US$33.35

M-Line Moen cartridge -- M1225

Moen https://www.moen.ca > products > M-Line > M1225 Moen Cartridge · Designed for 1 Handle lavatory, kitchen and tub/shower faucets (after 1959) · Replaces O.E.M. 1225 · Backed by MOEN's limited lifetime warranty.

MOEN #1225 Single-Handle Faucet Cartridge

Home Depot https://www.homedepot.ca > ... > Faucet Cartridges It maintains a balanced pressure of hot and cold water. This cartridge assembly is ideal for Delta Monitor 1300 and 1400 series tubs and showers. See less ... In stock

Moen 1225 One-Handle Kitchen and Bathroom Faucet ...

Amazon.ca https://www.amazon.ca > Moen-1225-One-Handle-Repl... Replacement faucet single control cartridge; Fits all single-handle kitchen, lavatory, tub, and shower Moen and Stanadyne faucets; Eliminates hard pull ... "); background-repeat: repeat-x; display: inline-block; overflow: hidden; position: relative; background-size: 14px 11.4px; height: 11.4px; width: 68px;">"); background-repeat: repeat-x; display: block; background-size: 14px 11.4px; height: 11.4px; width: calc(62px);"> Rating: 4.6 · ‎ 5,065 reviews · ‎ $33.34 · ‎ In stock ..

Posted to Home Plumbing category, so one of these https://www.google.com/search?q=vintage+sprayer+spray+head+diverter Or Garden Sprayer like this? You can get a vintage new wand on eBay. https://www.google.com/search?q=vintage+garden+sprayer+nozzle All questions need FULL 'make model (what is is)' as first 3 words. ..

This seems like a system which is proprietary to them, so best to ask their Support staff https://mirolin.com/contact-us/ You could have retrieved the old spring with a flexible magnetic reach tool. https://www.google.ca/search?q=magnetic+pickup+tool https://www.google.com/search?q=Mirolin+bath+drain+stopper ..

not a car moved to Plumbing ask maker for support. if the hardware store has no answer you ask maker or google for ever. I will not do.