How to convert polar to rectangular form - Casio FX-115ES Scientific Calculator

SOURCE: canverying polar to rectangular

Hello,

Here are exemples from the manual.

SOURCE: how to change from phasor/polar form to

Hit [Mode] then arrow down until you can choose Rect, then hit [Enter] then [2nd][Quit].

SOURCE: can you show how to convert pola to rectangular o

Hello,
To avoid errors make sure that the angle unit is THE ONE required by your problem. To verify or to change the angle unit press [SIFT][MODE] and select [3: Deg] for degrees, [4:Rad] for radians, or [5:Grad] for grads.

Convert from rectangular to polar

[SHIFT][+] (Pol) . Screen displays Pol(
You enter the X-coordinate, and the Y coordinate separated by a comma, then you close the parenthesis and press [=].

Exemple: Polar coordinate of the point (1,1)
Pol( 1, 1) gives
r=1.414213562 (square root of 2)
θ=45

Here is how you enter it
Press [SHIFT][MODE][2:LineIO]
[SHIFT][POL] 1 [SHIF] [,] 1 [)] [=]

The screen displays
Pol(1,1)
r= 1.414213562
θ= 45

Convert from polar to rectangular coordinates

Rec ( radius, angle) =

Exemple: Recatngular coordinates of (r=3, θ=60°)
[SHIFT][Rec] 3 [SHIFT][,] 60 [ ) ] [=]
The screen displays
Rec(3,60)
X= 1.5
Y= 2.598076211

Hope it helps.

Testimonial: "thanx that was very helpful"

SOURCE: how to change polar form to rectangular form by calculator?

Use the Rec function (shift of the - key).

Rec(r,t) converts a polar value of magnitude r and angle t in the current angular mode. The real value is assigned to X and the imaginary value is assigned to Y.

Use the Pol function (shift of the + key) for the reverse.

It's on page E-37 of the manual. If you've misplaced your manual, you can download a new one from http://www.casio.com/support/manuals

SOURCE: i am a casio fx-82MS user. i would like to know

Hello,
Press [MODE] and select [1:COMP]
Press [SHIFT][MODE] and select [3:Deg]. You can also use rad if the angle you are given is in radians.
To start the conversion
Press [SHIFT][-] (Rec) screen displays Rec(
Key in the radius r , ex: 3 screen displays Rec(3
Press [SHIFT][)] (,) to enter comma separator Rec(3,
Key in the angle in degrees, ex: 57.3; screen displays Rec(3,57.3
Press ) to close parentheses; screen displays Rec(3, 57.3)
Press [=]
Screen displays
Rec(3, 57.3)
X=1.620720961
Y=2.524532346

X and Y are the values of the coordinates.

If angle is in radians, [SHIFT] [MODE][4:Rad] the command
Rec(3, Pi) gives X=-3, Y=0

I just realized that your question pertains to the FX82MS but is listed under the FX115ES (That is quite a difference) So my answer above does not concern you but I will leave it as is should anyone need the answer for the FX115ES.

Look at the enclosed screen capture for the FX82MS