Question about NT1A Professional Microphone
...anymore and there's terrible distortion on "Sss" sounds and plosives ("p", "t" sounds etc.). The mic has been reduced to a kids plastic toy mic! Could it be condensation? This is typical component ...
I am being told it too much madulation. I turn power level dwn and mic gain dwn but still no luck same sound. crappy mic? Don't use a power mic, use a stock mic. When the radio was modded, it was done
...mods can i do to my cobra 19? tune up, swing mod, talkback, any thing that can be done to a cobra 25 ltd can be done to any 40ch cb.. just add a power mic$17.99 or a good echo mic will make a huge ...
...is factory set at 50 to 90% modulation. I would not turn it up all the way unless the radio has a mic power output adjustment on the panel. This way if you go "over mod" you can cut back the power. ...
...mic was being depressed while not he called a repair shop in erie supposed to be rep for connex called him no longer doing repairs was told to send to factory Do it have a relay mod for the talkback ...
...mic on a different set works fine Look at Radio Mods or Defcom mods. To clip modulation diode inside radio. Take to Cb shop to Peak&Tune. It may be wound to high in carrier but not audio. Buy ...
...mic jack in the radio doesn't have a broke or loose wire. Those are a few things I can think of based on the information given. More information is needed if these will no solve the problem. Does ...
Question about 19dx Iv Eu Multiband Am Fm Cb Radio With Mic - Am & Fm
will a cobra power mic cure the low mod on my cobra 19 dx iv eu or will it blow the front of the rig experiancing very quiet mod. Will a power mic fix this. I have been told by a local ham radio shop ...
Question about DX-95T Base CB Radio
my galaxy dx95t , not sure if finals have blown, i key the mic and gives a reading of 60w on fm but when i flick the front panal switch to mod the needle reads 0 , talkback works fine , ssb the needle
...speaker works,RX works , no audio on test radio just signal strenth. Have you tried another mic. First guess microphone wire broke or broke solder for audio wire in mic jack at mic
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions
