Questions & Answers for: amp goes protect plug rca

Question about D400.2 Car Audio Amplifier

2 Answers

Amp automatically goes to protection mode I recently hooked up my SoundStorm D400.2 amp and it wouldnt work. Every time i plug in my RCA jacks it went to protection. I had it hooked in there before ...

Ad

Question about D400.2 Car Audio Amplifier

1 Answer

...amp kept on going to protection, i have now changed my wires and put new speakers but still goes on protection. You say the protection mode only occurs when you plug the RCA's in. Does it have to be ...

Ad

Question about D400.2 Car Audio Amplifier

1 Answer

...the RCA wires in, the amp goes in protect mode. The light is not green eithe when the RCA wires are not hooked up. I don't know what to do... seems like the rca jacks are loose on the inside of the ...

Question about D400.2 Car Audio Amplifier

2 Answers

goes on when i turn the amp onbutas soon as my headunit sends the signal to the amp the red protectlightgoes on. i disconnected the rca's and the speaker wire and when iturnedthe car on it stood green

Question about PD-394 Car Amp

1 Answer

amp goes into protection when the circuitry over heats.\ First decrease all your gains to minimal volume. Connect your 12+V, remote, and ground. See if the protection light comes on then. Next plug in

Question about (RC1000A) Car Audio Amplifier

1 Answer

...amp it goes into protection mode! Why? You have a ground fault. Check all ground wires and then make sure the rca cables are not broken in any places. If everything is good there is a ground fault ...

Question about A-500 Car Audio Amplifier

1 Answer

...amp; same problem. Should the amplifier go into protect mode, simply disconnect all RCA and speaker leads, while keeping +12 volt, power ground and remote leads connected. 1. Now turn the amplifier ...

Question about A-500 Car Audio Amplifier

1 Answer

...Amp goes into protect mode when rca's r plugged in, there r 3 sets of preamp out puts 1 front left and front right, 2nd is rear left rear right, 3rd a single blue sub connection....yet there is ...

Question about A-500 Car Audio Amplifier

1 Answer

...amp back on(you will only have power, ground, and remote wires plugged in at this time) and if the red protect light goes away, then there is a problem with the input/output speaker wires, this ...

goes into protection only when left rca channel is plugged in, right channel works fine I have a kicker cxa1200 with line level input from door speaker wires connected directly to rca female jacks and

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Car Audio & Video Experts

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

73781 Answers

Brad Brown

Level 3 Expert

19190 Answers

ADMIN Eric
ADMIN Eric

Level 3 Expert

42220 Answers

Are you a Car Audio & Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...