Questions & Answers for: cancel button flashing dishwasher

...off the circuit breaker for 45mins to reset the machine. That didn't work either. The Cancel light came back on and is flashing. Any suggestions? Try holding the reset button in for about ten

Cancel/Drain button will start the pump. While the pump is running, the Lock On light flashes 3 times (quickly), pauses, flashes 3 times, etc. Once I was able to get the cycle to start. The dishwasher

...now. Pressing ancel only makes the cancel button blink as well. Pressing and holding the cancel button makes the quick rinse button blink as well. HELP!!! Sounds like a defective control

...a Kenmore machine is to press and hold the "No heat dry" button for longer than 4 seconds. This should cancel the lock and resume normal function. Hope this helps. Please do rate this answer.

...cancel button.It will clear any existing faults and makes the dishwasher to operate normally. To prevent the issue from recurring, run your hot water faucet first to ensure that hot water is present ...

...I reset the unit (breaker), only the Smartwash button is flashing. I push cancel and then it starts flashing. So I think the buttons work, but it's locked up. IS THE WATER TURNED ON TO THE ...

...cancel button.  That should cancel all lights.  Then press wash button then start.  If the light is still flashing after you turn off breaker....you might have a bigger problem.  ...

...button has a steady light. I unplugged dishwasher, I have pushed cancel, cancel and heavy duty and cancel and normal wash together. Sounds like a logic board problem. You may have to change the logic ...

...Cancel/Drain" button once your dishwasher has completed its diagnostic test. This should reset your dishwasher control panel. Check to make sure that there's no standing water in the bottom of your ...

...pump. If any panel lights remain on, or start flashing, press Cancel button until none are seen. If the Steam/Sanitize panel light is on, you may need to press that button before you can press