Questions & Answers for: chainsaw won t start

Won't start. Plug is firing. Primer bulb gets full. Still won't start. These machines have had issues with main bearing cages breaking up, this it turn scores the piston and snags the ring in,

chainsaw starts easily. But the chain won't move at all. Sounds like the chainbrake has activated, grab the hand guard and pull it firmly back to the top handle, until you hear an audible click as

My Ryobi 4545 Chainsaw started but would not tick over. Now won't start at all. Check your anti kick back bar across the top. If you bumped it forward will not start.

...chainsaw that runs fine when cold but after about ten minutes of operation it won't start again? If I let it cool down for a hour or two it will start up again. What do you think the problem is? ...

...chainsaw wont start checked the fuel filter, spark plug, coil....it has spark and is getting fuel, it just won't start Try bypassing the switch by connecting the two wires together. If it starts ...

16" blade won't turn, but starts right up, electric 16" blade won't turn, but starts right up, electric clutch is either bad or has sheered the key

Chainsaw won't start. Replaced carburetor, fuel lines, fuel filter, ignition module, spark plug. Using new gas and oil. Has good spark but won't pop. Chainsaw won't start. Replaced ...

Chainsaw won't start. Has spark, has fuel, chain Chainsaw won't start. Has spark, has fuel, chain stop works and is in the right position for starting and on/off switch is in the on position It ...

...chainsaw won't start. I took out spark plug, put in some fuel and if fired right up. But won't run. homelite xl chainsaw won't start. I took out spark plug, put in some fuel and if ...

...chainsaw won't run without full choke on and My chainsaw won't run without full choke on and gas trigger wide open, won't idle without dieing? Fuel starvation, start by replacing the fuel ...