...radio went out in the middle of Gustav, but the flashlight worked if I hand-cranked it. Took it to the local Vector/Black and Decker/DeWalt service center and was sent a new one in about a week. I'm ...
...radio switched off, press the Step/Band button for about 10 seconds. This will display FM and a blinking 50Khz with a single beep sound. By rotating the Tuning Control you can increase or decrease ...
...dewalt dc011-radio, all the pre-programmed radiostations are lost. I have to reset he clock and the radiostations, every time I turn on the radio... Have you installed 2x aa batteries in the back ...
Dewalt DC013 Can't get the radio to retain the programmed channel when it's switched off. It also looses the time. Any ideas? Dave Keep it plugged. If it runs on batteries, keep batteries in. But do ...
...radio stations may be independently set. After programming the buttons, pressing 1, 2, 3, 4 or 5 will instantly change the frequency to the preset station. 1. Turn power on. 2. Set the radio to ...
Question about DCO11 Radio
My Dewalt dc011 will not hold memory anymore. Every-time powered up I must re-program stations Worked fine for two years and still holds channels if not turned off Fuse or some thing keeping the ram ...
Usually answered in minutes!
6,442 Questions
5,455 Questions
4,073 Questions
2,449 Questions
2,268 Questions
