Questions & Answers for: distributor reference

Question about 1987 Mustang

1 Answer

...DISTRIBUTOR ITSELF WITH A REFERENCE TO THE MOTOR THEN UNTIGHTEN THE 13mm BOLT THAT KEEPS THE DISTRIBUTOR TIGHT. TURN THE DISTRIBUTOR SO YOU CAN ACCESS THE BOLTS TO THE "TFI" ONCE YOU SWAP THE "TFI" ...

Ad

Question about 1991 Eclipse

1 Answer

new distributor no old one I've a 91 Mitsubishi Eclipse I've bough anew one but do not have old to refer to. Are there any refere marks on to plese rotor cap in right plese? distributor is use only on

Ad

...says no distributor refrence signal. there is no distributor. Bad Distributor, change and that will take care of the problem the reference signal comes from a disk and a pick-up in the ...

...reference point on distributor body as well as engine block . Remove cap and wires , loosen distributor lock down bolt , disconnect distributor wire harness and label harness for reference to ...

...reference when reinstalling the distributor. Loosen and remove the distributor hold-down bolt and clamp. Carefully begin lifting the distributor up and out. Once the shaft is clear of the engine ...

Question about 2001 Jimmy

1 Answer

...distributor Remove the wires and cap making note of which wires go where. Make a reference mark where the rotor is pointing on the intake. Usually a crayon or something similar is pretty effective. ...

...distributor, a crank sensor and pulley with a reference point for the sensor, a control module, coil, cap, rotor, wires, and you should be good to go.the CKP (crank sensor) tells the module when to ...

Question about 1999 Silverado 1500

1 Answer

...reference mark as the distributor sets all the way back down flush on the intake manifold. 2. Install and tighten the lock down bolt, and If the distributor is properly installed then the ignition ...

...is the Crankshaft Position Sensor located on a 94 VW jetta GL 2.0? this sensor is integral to the distributor. it is a common failure, and requires that the whole distributor be replaced. before ...

...distributor reference pulse input" to the computer. This serves much the same purpose as a crank position sensor. The little star-looking ring on the distributor shaft, below the rotor? It works with ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

73781 Answers

ADMIN Eric
ADMIN Eric

Level 3 Expert

42220 Answers

john h

Level 3 Expert

29497 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...