I have a 1993 chevy c1500, 5.7 V8, 2wd, automatic. two months ago i had to replace the distributor after being unale to locate the cause of a weak spark. now I have no spark, replaced the dist, (came ...
...shaft is bent or not seated. Remove cap and observe the distributor shaft as someone cranks the engine. Does it wobble? Can't tell? Place a stiff reference parallel to the shaft and turn engine
...distributor cap. It's a coil pack engine. If you've got your power, ground, and illumination taken care of and all you need to do is connect your tach signal lead... Pull your instrument cluster out. ...
...reference to ensure you don't cross them when reinstalling the new distributor cap. Remove the two torque screws in the distributor cap and remove the distributor cap to access the rotor. Remove the ...
350 chevy distributor what are the two wires that hook to the battery terminal what is the purpose of each wire? 1 is for battery to the distributor, the other is for a tach reference.
...distributor and rotor were removed without being marked. The book states that the rotor should be pointed at 6 and in time with the marks on the pulley. As far as I can see, there are no reference ...
...reference mark as the distributor sets all the way back down flush on the intake manifold. 2. Install and tighten the lock down bolt, and If the distributor is properly installed then the ignition ...
...you tell me what has went bad p1345 refers to Camshaft to Crankshaft correlation problem. Could be distributor turned at wrong angle in relation to where it should be: Camshaft ****** Offset ...
...it. Can you give me an idea where it is? Thanks for choosing FixYa. Your cam is built in the distributor. You will have to change the entire distributor to fix
Question about 2002 Blazer
...an y help would be greatly appreciated pick-up coil, also referred to as a pole piece is inside the distributor, pulses from the reluctor... R&R ...
Usually answered in minutes!
8 Questions
8 Questions
2 Questions
2 Questions
