Questions & Answers for: etq generator problems

ETQ 8250 generator and pressure builds in fuel tank and pushed fuel into crankcase. I drained oil and gas from crankcase and refilled with gas and oil restarted and it smoked for a little while then I

...ETQ 1200w Generator I bought unworking. I have cleaned the air filter, reattached the choke switch, put new fuel in it, and checked the spark plug. What do you suggest troubleshooting next. T I have ...

...etq in1800i portable generator, or any information on the engine. The carburetor was pretty dirty, after removing and cleaning, it still won't run. I can get it to run for a few seconds if I spray ...

Keeps bending pushrods Bought used had broken rocker arm bent rod replaced both push rods and arm it did it again after a week It sounds like your tolerances on cams, etc, inside the engine are out of

...etq 1200 generator that runs but doesnt have ac. what could be the problem? Check that the GFI receptical is not tripped Check that there are no blown fuses or tripped breakers Verify that the engine ...

...etq 1200 ,would one of these be the problem, magneto,igniter ir capacitor? Checked compression,gas& changed the spark plug twice. All of the above are good! A lot small ignition spark appears to be ...

overload light stays on Generator was in storage for 2 years ( worked fine before putting away ). Pulled it out this week, replaced oil and spark plug. Filled with new gas and started it up no problem

ETQ 3600 generator runs but no power output First check the winding resistance, and the connections. Hi! We can help. Chances are it is the AVR failing.Check out our help centre to diagnoses the ...