Questions & Answers for: forest chainsaw start

from day 1 it has been hard to start can't start this morning I cain't start it Please unit is 3 hours used If it's new take it back to dealer,should have come with owners manual>

my 345 chainsaw bogs down when it hits wood my chainsaw starts right up idles fine but it doesn't seem to rev as high and as soon as it hits wood it bogs down and just wont cut for ****. I have ...

...start a new Husq 235 chainsaw. I put new gas/oil in about a month ago and it ran great. Tried to start it today and it acts like the ignition is not ''on''. I primed it, choked it, tried holding the ...

...chainsaw running and started messing with carb. setting now it wont run. Most chainsaws and small engines are 1.5 turns out. You need to set the mixtures for the carburetor. You will find a Low and ...

...chainsaw runs when using starting fluid or pouring small amount of fuel in carb, then quits. Suggestions? Check the fuel lines for cracks/breaks. If they are o.k., then: You willneed to disassemble ...

Model 445 chainsaw. Was cutting all day and no problem. Good gasoline, Husqvarna 2 cycle oil. All of a sudden started racing like the carb was stuck full open even when throttle trigger released. Then

I have a Husqvarna 41 model chainsaw. It starts fine and runs, however as soon as I let go of the gas it dies. It seems like it is not getting enough gas. Any suggestions? check crankshaft sealings. ...

chainsaw will not start never run, just added fuel mixture and cahn oil. primed six times, pulled out choke and pulled . nothing, no kick or anything except a sore arm. is the kill switch on?check the

I have a husqvarna 345 run for a few cuts then stops. I have a Chainsaw that runs for a few cuts then "boggs" out and shuts off. I then proceed to pump the primer ball and it fires right ...

after my 345 Husqvarna works for a bit cutting wood, then If I shut it down it's always very Hard to start? Why gas bleeding off the carb someplace