Questions & Answers for: high flo pump

...High Head pumps like, Super II, Challenger, Ultra-Flo or the Sta-Rite pumps. # Pool/ Spa combos with at least 3 lines influent and 2 - 3 back to the pool, 2" plumbing may be able to handle the Ultra ...

...flo"....Pump 1 doesn't sound like its kicking on...Pump 2 kicks on...cant get pressure into the filter... Any suggestions? you must have a small pump call laing if you do, air picket inside the ...

...flo-master 56 frame xp2. I have a new pump that was improperly wired from the factory.It is a two speed pump only running one speed. If I knew where the factory wiring should be landed, I'm pretty ...

flo tek pump that the inpeller needs 2 be replaced. dont need the whole pump just inpeller but no web site i have gone 2 sells just that inpeller flo tec model fp 5182-08 pleas help You can always try

...flo master power cord to new waterway pump diagram say common white line to port no 1 port no 1 hase an orange wire on it allready wire leads in to motor housing. not sure where white line goes. tub ...

...Flo-Master stuck in high speed after turning on and off the electric I have a Flo-Master Aqua-flo two speed 1.5 - .18 SF pump on my hot tub. Turned off the electric to the pump for spa maintenance, ...

...flo error and does not start at high or low speed. The water flow in hot tub is strong so I don't think anything is blocking the flow. I suspect the pump has some part worn out that is making ...

Which wire goes to h, which wire goes to c, which wire goes to l? The black wire goes to H (high) White wire should go to C and green to the I. Rod US Parts Center

...switched on. It appears to work on low setting but trips when jets and air are switched on - any ideas? Doug This is usually an indicator that the high speed on your pump is bad. Rod US Parts ...

Hi,i have an aquaflow xp2 flowmaster pump 2 speed.it runs on low speed but wont run on high speed capacitors have been checked and all good does anyone have any ideas ? you need a 2 speed relay