Questions & Answers for: Canon insert fuser Computers & Internet

...then back on, but that did not help. Any other ideas? Thanks first verify that the fuser drawer is inserted correctly and there is no debris in the fuser connector. Also check the fuser for paper ...

...Insert paper clip into hole (inside machine), then * * and service mode shud activate, then click error code and clear all errors. 2. The film is out of place, the fuser needs to be removed and the ...

CANON IR C6800 FIND THE ERROR CODE E00006-0001 That code is refering to the Fuser Unit being inserted fully. Have you tried pulling the Fuser Unit out part way, then reinserting fully. If this does ...

of reset besides the one in service mode? see if the heater turn light...if not the unit one is not inserted properly...

fuser temperature correctly. It may have to be replaced. You should try resetting the error first. Open the front door and look for a small hole in the cover below the control panel. With the power on

...fuser unit u can solve it by press *28* then goto copier then function then clear and clear err dc-con err-hist jam-hist and pull both 1st and 2nd drawer now restart and when the screen is ok again ...

...to the left so that the access holes align so that a long shafted phillips screw driver can be inserted to remove the three screws securing the fuser assembly. Then bend back the black milar ...

Insert it correctly.If problem is still there then this problem is usually caused by the Fuser assembly or Tension Roller of the printer. You need to change the tension roller of the printer

...unit.... Clear the error and restart the machine problem will be solve.... The white mark of the fuser film on the right side replace properly if you insert reversely same problem will be

...can take to investigate and solve the issue. a) Double-check to make sure the toner catritdge it is inserted properly and firmly into the printer. b)Considering that you mentioned replacing the fuser ...