Questions & Answers for: jh600

i have an amp tha i bought its a jackhammer JH600 ..my problem is that the power light on my amp isnt turning on ???even the bass is still hitting, but not the same as when the light is on!!!! bad ...

mtx jh600 feed back in subs light on amp the bolt is blinking I just had the fuse in my amp kit blow so I replaced it, AGU40, with a new one. When I start the car my subs just start hitting with now ...

no power no powe when plug up Internal problem, refer to Manufacture

why does the amp not turn on or go o protection is it burned ??? either the output amplifier is shorted or the one of the speaker voice coils is

how to bridge this jh600 amp??? i have it on neg. side on left and positive side on the right fofr

when i hook up my amp the fan goes on then yellow light starts blinking check your wiring's and make sure it is properly grounded.

a red light came on and i dont know what that means its eiteher blowed or its in protect mode especially if its hot when light comes on

i just bought a new jackhammer jh600 mono block and i installed it, but as i turn the car on. the light on the far right starts flashing and makes a beeping noise as well with the two 12 inch explode ...

My MTX JH600 works intermittently. I don't hear the fans coming on at all and the amp doesn't seem to get hot. Even at low power the amp will turn off all of a sudden and then boom back on ...

getting a blue light but no bass from sub woofers, hook up correctly. check ur rca jacks make sure there connected also on stereo make sure subwoofer setting is on and turned up,bass,fader etc...