Questions & Answers for: laminator feed

...feed my item through the laminator. Usually I just put it in and the laminator feeds it out the other end... Make sure your laminator is heated up properly before feeding material through. Usually, ...

...laminator, normally they have a cleaning sheet, but not always, and if you do not have one, you can improvise by taking a section of craft paper bag, fod it over and trim to width of the laminating ...

...laminator can't feed plastic sheet through You will need to make sure that you are using the right type of plastic. also, is the plastic the right size? Also, you need to check if you are ...

...laminator and it will not feed It get hot but the feed dose not work. Unplug the machine. Then try to look, using a flashlight, if there are any obstacles that may interfere with the feeding. try to ...

...will not feed If the motor is running, then the cog that drives the roller system may have failed. Laminators built today are made with plastic (nylon) roller drive cogwheels that crack. Especially ...

Laminate Film Disconnected While putting on new rolls of laminate the lower roll separated from the lead so now I have nothing to attach it to to get it to go around the rollers. What do I do? Un-coil

...LEFT of the laminator. You ca try to feed another film in....hoping it will force the pouch out. Otherwise, you will have to take the cover off and unroll the pouch from the inside rollers. Good

...feed New laminating film through straight? Top roll of new film is wrapping around bottom heat roller I have both rolls with dull sides together and not feeding straight through, wants to wrap around ...

laminating pouch wont feed through the rollers The pouch scrunched up so I turned it off, then pulled it back out towards the front. Now a new pouch wont feed through You need to take it apart and see