Questions & Answers for: lights flashing washer

...LIGHTS FLASHING ON/OFF AND MINI LOAD LIGHTS ARE FLASHING AND THE MACHINE WILL NOT SPIN The lights are set off by the balance sensors.And if your balance sensors are stopping it from spinning than you ...

...flashing but washer won't operat... Start light keeps flashing but washer won't operate. Tried to reset by hitting cancel button but start light keeps flashing. Check whether inlet water is flowing ...

...lights are flashing and no power? On you old control there was a plug with just a jumper wire. This is the model select plug. Without this plug the washer does not "know" what model it is on and the ...

...flashing lights at the unit's start, door lock, wash, rinse, final spin and control indicators to display error codes. If the five indica tor lights flash more than nine times, this signals a letter ...

...flashing again, but the washer will not start. Kenmore 3.5 super capacity front load. Try unplugging the washer for fifteen minutes or so. If that doesn't cure the problem, i am sorry to say you have ...

...the washer cycle stops, constant flashing of the sensing light. Lid ock will sometimes flash and lock and unlock a couple of times. No water will fill. No agitation or spin. Drain pump will

flashing and the washer won't start lid light flashes even after power button is turned off Possible that the switch is defective, there is fault in the line to the control unit from the switch of

...washer wont start a cycle, lid does lock and the locklight ... a cabrio as well that just has the lid lock flashing and nothing happens , I ... Flashing Lid Lock Light: How to Troubleshoot Errors on ...

flashing ... GE Washer Start button flashing - DoItYourself.com Community Forums www.doityourself.com/.../386041-ge-washer-start-button-flashing.html Apr 6, 2009 - GE Washer Start Button flashing will

...flashing on amana washer drains then stops and rinse light flashes My Amana washer is stuck on rinse Replaced the drain pump, motor, actuator, resistor and recalibrated and still getting the flashing ...