Questions & Answers for: normal starter amp draw

Question about 1997 Tahoe

1 Answer

...normal, thought it was starter. put on new starter same thing, nothing, After taking old one off, Tested and worked fine, same with new one. Any advice? You need to try and jump start the vehicle and ...

Ad

...amp draw could be caused by a bad starter main lead,look for bubbles in the insulation along the entire wire. this is an indication of corrosion inside the insulation which will greatly increase amp ...

Ad

...starter while the cranking amp draw depends on the displacement and compression of the engine. Always refer to the OEM specs for the exact amp values. Some "high torque" GM starters, for example, may ...

Question about 2005 Durango

1 Answer

...starter while the cranking amp draw depends on the displacement and compression of the engine. Always refer to the OEM specs for the exact amp values. Some "high torque" GM starters, for example, may ...

Question about 2000 Montana

1 Answer

...normal for when the starter is turning. If the starter doesn't turn and draws that many amps then the starter is bad. If you get 0 to 3 amps and the starter doesn't turn it's a bad connection or bad ...

...bad solenoid. Also, if the draw is 75 to 125 amps and it doesn't turn, the starter is bad. Normally, a starter should draw 75 to 125 amps and turn vigorously, assuming the battery connections are

Question about 1988 323 Hatchback

1 Answer

starter, so at start the current draws will between : 3X ( 26.4 to (26.4(1 +35%). And After start up the current draws will drop to 26.4 to 26.4(1+ 35%) in normal operation. Remember, that the current

...normal for a 94, you could have a bad starter. I have seen starters with worn bushings crank OK when cold, but when hot, the armature will drag and cause low/no cranking speed and an excessive ...

Question about 2007 B4000

1 Answer

...a high output amp meter to test starter draw. normal ampere draw should be 250-350 amps cold and 300-375 amps hot as engine turns these readings should drop to 200-250 amps if not bad

...amps are required to start a 1994 Mercury Grand Marquis LS? How much does the starter draw or the entire vehicle, while cranking the motor? Normal amp draw for a 4.6 engine at 70 degrees is 250 -

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

73781 Answers

ADMIN Eric
ADMIN Eric

Level 3 Expert

42220 Answers

john h

Level 3 Expert

29497 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...