...to Test 38. If there are no damaged terminals, proceed to step 4. With sensor disconnected, connect ohmmeter between 60-way connector terminal No. 67 and ground. If ohmmeter shows continuity, proceed ...
...COIL (HEI) 1. Isolate 2 pick-up coil lead wires. Remove pick-up coil connector from module. Connect ohmmeter to either terminal and ground. See Fig. 4 . Connect pump and apply vacuum to test vacuum ...
Question about Atlantis MDE7400AY Electric Dryer
...of things, firstly an overheat protection thermal fuse is in the rear of the dryer check it with an ohmmeter it should have a low resistance at room temp. Next check the start switch under the button ...
...power steering pressure switch on a 93 caddy deville.My Haynes repair manual tells me to connect an ohmmeter to the terminals on the switch body,start engine,turn wheel and read the ohmmeter... ...
...Engines See Figure 1 Tag and disconnect the distributor lead and wiring from the coil. Connect an ohmmeter as shown in Step 1 of the accompanying illustration. Place the ohmmeter on the high scale. ...
Question about HZ519 Baseboard Heater
...the control panel, pull the control out from the body of the heater enough to get the probes of an ohmmeter onto the connections that lead to the heating element. the ohmmeter should read less than ...
...The following test must be made on one-, two-, and three-speed drive motors: 1.Touch and hold one ohmmeter probe to the terminal on the white/black wire from the motor. 2.touch the other ohmmeter ...
...The following test must be made on one-, two-, and three-speed drive motors: 1.Touch and hold one ohmmeter probe to the terminal on the white/black wire from the motor. 2.touch the other ohmmeter ...
Question about Duet GHW9150P Front Load Washer
...The following test must be made on one-, two-, and three-speed drive motors: 1.Touch and hold one ohmmeter probe to the terminal on the white/black wire from the motor. 2.touch the other ohmmeter ...
Question about Duet GHW9150P Front Load Washer
...The following test must be made on one-, two-, and three-speed drive motors: 1.Touch and hold one ohmmeter probe to the terminal on the white/black wire from the motor. 2.touch the other ohmmeter ...
Usually answered in minutes!
4,236 Questions
3,747 Questions
3,350 Questions
3,279 Questions
3,218 Questions
