Questions & Answers for: printer tray 3 showing

tray 3 is not showing up at all in the printer properties dialog box. Any suggestions? tray 3 not showing up in the properties box for my hp 4200 Have you re-installed the driver recently? Perhaps you

...tray 3. With the copier turned on do the following Open paper tray 3, remove paper, close tray, open then shut front door, load paper into tray 3 - hey presto!! If the fault comes back you could have ...

tray and printer stops after printing 3 or 4 pages. I open and close the top access and printing resumes for 3 or 4 more pages...stops and shows paper jam at feed tray. Repeat open and close of access

...Printer. It has the optional 2000 Sheet Tray 4 and that is where the problem is. Tray 4 shows that it is out of paper, yet there is paper in the tray. I have psyically watched it lift to the upper ...

tray appears to be lowered all the way, but the printer will not print & continues to show the error message. Thanks! David lift the paper exit tray 2. lower the paper exit tray again 3. press the

...tray 2 in HP Laserjet p3005n printer HP printers will default to the highest numbered tray that contains plain letter paper. So on a standard 3005 Tray 2 is the default unless you have the paper type ...

...printer off of tray 3 there is a possiblity that the connector broke when putting the printer back on. You say not recognized, is that through the printer driver? Print the configuration page for the ...

...replaced, 2.replaced paper feed mechanisam 3.replaced tray2 still same. Some times open and close tray 2 printer starts printing one page and show the same error. Clean the feed rollers. solenoid ...

...printer to tray is making connection and it appears to be. The manual says you can't interchange trays, and although I had them all out and they could have been mixed up, I don't think this is the ...

Tray 3 not showing up on my printer I have a Konica Minolta Bizhub C20 and the tray 3 in the paptjer setup does not list tray 3, any ideas why. I removed the top printer and checked the connections, ...