Questions & Answers for: Roper remove shell Electronics - Others

...shell off . I am replacing the pump. i have the top where switches are laid back, now how do i open the top Hi You are on the way. Since you have the switches laid back now with clear space in front ...

shell of the machine to get the Screw that is logded out. ok llangis,,ready always unplug first,,good,,,now look at the front console you see a screw in each corner,,phillps head,,remove them now flip

...remove the outer machine shell to gain access first remove the two screws that hold in the control panel and tip it back, then there two clips that the shell is locked onto undo them and pull the ...

...remove outer shell in order t gain access to drain pump I believe Roper washers are manufactured by Whirlpool. The following link should provide you with the necessary steps in removing the washer ...

remove the shell. How do I change the drive link? take the screws and brackets holding the motor and pump, pull it to the side and you can see where to replace the drive link whirlpool 7 speed 2 cycle

water inlet valve swap Is this a hard job? Should I take it to a repair man? It all depends on your skillset. Here's what is involved... Removing 2 screws on the control panel. Removing the outer ...

...remove the outter shell of the washer you'll need screwdriver a 1/4 or 5/16 socket a hammer/mallet and a piect of wood that fits between the pegs and tap on the motor shaft and the other fits on the ...

...washer leaks how do you remove shell to fix there is screws on the bottom of control panel remove screws then control slides foward and up. Under that there is clips that hold the cabinet into

I have a Roper RTW4340SQ0 washer that leaks profusely when it fills and throughout the washing cycles. I've checked the water valve and all the hoses associated with it as well as the pump and all the