Questions & Answers for: how to replace fuser thermistor

Question about Panafax UF-585 Plain Paper Laser Fax

1 Answer

...replace it the fuser thermistor makes contact with the heat roller. Normally they are in the middle of the roll. If you are experiencing a fuser error. Most likely the upper fuser will need to be ...

Ad

Question about DocuColor 12 Printer

2 Answers

...replace the fuser itself. Initial Actions Refer to BSD 10.2 and 10.12 for the following procedure. Perform the following: 1.Open the Drawer and extend it to the service position. 2.Remove the Oil ...

Ad

Question about FS-1118MFP Laser Printer

1 Answer

...heater lamp installed incorrectly. Check and reinstall if necessary (See page P.1-5-19).Broken fuser heater lamp wire. Check for continuity. If none, replace the fuser heater lamp (See page

Question about T430 Laser Printer

1 Answer

...either disassembling the fuser and replacing the thermistor ( if you can find one) or replacing the fuser assembly. so i would suggest that take it to nearest service centre of lexmark. best of ...

Question about Infoprint 1572 Laser Printer

1 Answer

...replace the fuser top cover assembly. 3 Fuser to system board cable. System board Fuser assembly Reconnect the thermistor cable to J5 on the fuser board. Disconnect the fuser to system board cable ...

Question about FS-2000D Laser Printer

1 Answer

...482°F or more continuously for 3 s. Shorted fuser thermistor S. 1. Measure the resistance. If it is 0 Ï?, replace the fuser thermistor S. 2. Defective engine PWB. Replace the engine ...

Question about WorkCentre PRO 128 Copier

1 Answer

Replace the Fuser Unit Yes)Check the resistance of the Main Lamp between P600-3 and P600-7 for an open circuit or a short circuit . The resistance of the Main Lamp is 100 ohms or lower. No)Replace the

Question about KM-1815 All-In-One Laser Printer

1 Answer

...Replace the fuser heater 1 or 2. Installation defectiveness on fuser thermistor 1 or 2. Check the mounting state of the fuser thermistor 1. If any problem is found, repair it. Defective ...

Question about FS-2000D Laser Printer

3 Answers

...replace fuser then reset the code from the manual sadjnbdsvknsdlkvnsdv Decompressed, rotated, relocated, or blanked-out image data does not complete within a specified period of time.TURN THE MACHINE ...

Question about FS-2000D Laser Printer

1 Answer

Replace the fuser heater M or S. Installation defectiveness on fuser thermistor 1. -Check the mounting state of the fuser thermistor 1. If any problem is found, repair it. Defective fuser thermostat.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

73781 Answers

ADMIN Eric
ADMIN Eric

Level 3 Expert

42220 Answers

Brad Brown

Level 3 Expert

19190 Answers

Are you an Office Equipment & Supplies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...