Questions & Answers for: sharpening poulan 3314

poulan 3314 poulan 3314 4 weeks old starts great idles fine, problem is when im on full throtle and cutting it will die and and splutter and miss and then stop. when it is not under load it revs fine.

how do i remove or change the clutch on my Poulan model 3314 chainsaw??? Remove cover,chain,& bar. Hold crank and turn clutch counter clockwise to remove.Replace in reverse order.

Poulan 3314 piston change, special tool needed??? I have a poulan 40cc saw, the crankshaft tip broke at the clutch. I have a replacement crank but need to change back to the original piston. Is there ...

what is the oil to gas ratio on Poulan 3314 Poulan and Poulan Pro chainsaws with 2-cycle engines require a 40:1 gas-to-oil ratio, which corresponds to 3.2 ounces of oil per gallon of gasoline.

poulan 3816, back fires through carburator, wont start. water in the gas or carb needs to be removed and taken apart and cleaned

poulin 3314 sat for two years. the engine will turn over but the sprocket with the clutch assembly can only be moved with channel locks. extemely stiff chain saw problem Is it rusty looking? Be sure ...

...3314 p CN anyone show me how to get the clutch off a poulan p3314 chain saw? Use a Poulan clutch tool and look at the clutch for the direction to rotate the clutch. There will be an arrow and It ...

chainsaw won't idle- runs fast only Gently Tighten the carb adjustment screw fully tight then adjust it out 360 (full turn) then again a further 180 ( half a turn) and your idle speed should be set ...

fuel line diagram for poulan model P 3314 http://www.poulan.com/ddoc/POUI/POUI2008_USen/POUI2008_USen__530165408.pdf

HOW WIDE IS THE GAP SUPPOSED TO BE ON A COIL ON A 3314 MODEL POULAN CHAINSAW .012"