Questions & Answers for: slack wire cable

...wire all connected, but upon squeezing brake, it doesnt tighten the brakes on the tire? I did no find assembly instructions specific to this model.  From what I see in pictures and descriptions ...

...cable from the solenoid and unplug the connector on the solenoid. The wires going to the starter are bolted to the transmission mount, it might be helpful unbolting that to get a little more slack in ...

wire is close to center under the vehicle, if you use a handle or foot pedal its on the driverside of the vehicle and Y's off to the passager side and driver side rear break EX: / --------------------

...slack in each cable. The throttle should "snap" back when you release the throttle. If not, work with it until it does. Failure to properly adjust and insure proper throttle operation can cause the ...

...wire in the window track is to slack and i cant figure how or where it tightens up if there is slack in the cable than the regulator is broken. A new regulator will need to be installed. You can find ...

...slack in the cable?  If it's just the outer housing is drooping away from the handle where it runs down to the engine, you can use some plastic wire ties, or electrical tape, or for a short ...

wire. After looking up your unit's info, I found that it does indeed have an aux input, but it's on the rear of the unit. Get yourself a 3.5mm aux cable (normal aux cable), pull the unit from the dash

...is adjusted by slacking off the outer cable clamp, or the inner wire clamp, placing the control in the desired position, placing the choke butterfly in the desired position, and tightening the

...wire against its own slack. I know replacement cables are available... but I've only ever had the cable itself break... or... it was simply missing... I had ABSOLUTELY NO PROBLEM finding lots of ...

...wire in the opposite direction of the hook while depressing the hood. This will give the hook some slack and make it easier to pull open. Pull up on the hood to open it, still applying tension to the ...