Questions & Answers for: starter amp draw

...starter while the cranking amp draw depends on the displacement and compression of the engine. Always refer to the OEM specs for the exact amp values. Some "high torque" GM starters, for example, may ...

Ad

...amp fuse at the starter relay switch it stops. Any ideas? using a 12 volt test lamp conected between the removed negative battery cable and, the negative battery post; with the fuses in place; you ...

Ad

Question about 2005 VTX 1300 C

1 Answer

...starter while the cranking amp draw depends on the displacement and compression of the engine. Always refer to the OEM specs for the exact amp values. Some "high torque" GM starters, for example, may ...

...bad solenoid. Also, if the draw is 75 to 125 amps and it doesn't turn, the starter is bad. Normally, a starter should draw 75 to 125 amps and turn vigorously, assuming the battery connections are

Question about 1996 C-Class

1 Answer

starter is bad. If the amp draw is only 1 or 2 amps and it doesn't turn, the solenoid on the starter is bad. And the starter will have to be replaced. Also, check the connections to make sure they are

...starter is going bad. Test with an amp meter at the battery cables (neg. or pos. side) and verify that 75 to 125 Amps is being pulled through the system. If it draws that much amperage the starter ...

Question about 2003 Explorer

1 Answer

...starter are shiny and clean when removed. Do an amperage draw test to see how many amps it draws when trying to start (click). If the amperage draw is 80 to 120 Amps and it doesn't turn over ...

...performing the test will know if Amp draw is excessive. 400 and above Amps would indicate starter is bad. Possible the negative ground strap is loose or burnt. It suffers from battery acid

Question about 2003 Explorer

2 Answers

...the starter motor and observe the amp draw. Consult the vehicle's documentation to determine if there is excessive amp draw. If the amp draw is excessive, the starter motor will require

Question about 2003 Explorer

1 Answer

starter draw amps kohler cv16s engine battery fully charged. safety switches working properly. solenoid is new. using inductive type amp meter, it pins over 400- 500 amps. will spin crank.. then binds

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ADMIN Andrew
ADMIN Andrew

Level 3 Expert

73781 Answers

ADMIN Eric
ADMIN Eric

Level 3 Expert

42221 Answers

john h

Level 3 Expert

29497 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...