Questions & Answers for: ventor Computers & Internet

...confussed. Well i think its the board but just looking for a second opinion. Call for heat and the ventor motor starts. after a few seconds the ventor quits and the main blower starts and the fault ...

...confussed. Well i think its the board but just looking for a second opinion. Call for heat and the ventor motor starts. after a few seconds the ventor quits and the main blower starts and the fault ...

GMP050-3 Ihave 3 blinks of the led is it the ventor blower or the ventor sensor i think i checked the sensor right put ohm meter accross pins then put a vacume to the hose sensor showed cont You ...

...box???? Is the pressure switch tubing installed correctly???...no holes in it???....and the furnace ventor motor is running????turn off the power and wait a couple seconds...turn the power back on ...

I have a York diamond 80 furnace. When I turn the unit on, the ventor motor turns on, burners ignite and the blower motor turns on ... Once the house get up to temperature the burners turn off, the ...

I have a York Stellar Plus furnace (1994 model) on which the ventor (air induction) motor will not turn off. This problem just started. The Furnace seems to work fine, but the ventor runs continuously

GMPN100-4 power does not reach the ventor motor even though there is power to the control board means if i check the out put wire to the ventor motor does not have power but when i disconnet the ...

...of the time the sequence of operation goes as follows: tstat calls for heat (R&W at tstat ) ventor motor starts, pressure switch closes, spark or hsi lights pilot or main burners. main blower ...

Diamond 80, controller is blinking Code 3 (Pressure switch stuck open). There is no AC going to the Ventor motor, therefore the pressure switch is always open. The blower does not come on in Auto mode

...needs pressed. We have searched high and low and can't find any reset button. Please help! :( your ventor motor has to come on first to close limit switch,follow tubing from switch to ventor motor ...