Questions & Answers for: raid failure - Page 3

...says boot failure master drive and secondary master drive i have ddr333 memory in. and also can i use a raid card which supports ide and raid drives (sata)? i had to buy the asus cables yes it ...

...closedown IRQ failures. I suspect this is something to do with the fact that the original Drive was RAIDed, and the new one isn't. So ..... either how do I set the new one up for RAID, or how do I ...

raid drive hard drives? I have an Xp 64 bit system that crashed. How can I recover the data from the hard drives? The failure of just one drive will result in all data in an array being lost. What you

...2807 It means that your raid is not seeing its drives. Usually after a power failure. Rebooting the server will fix it in the short term. To fix it long term you need to update the servers

raid controller was affected by power failure. it could not found the os, and it looks as if someone swap disks on my absence. its configured with raid 0.how do i establish correct location and origin

failure on my dual drive XPS 410 desktop. I have replaced both 320 Gb Western Digital SATA drives with two 500 Gb Western Digital SATA drives. Do I load the operating system on both drives? And how do

...RAID is only to protect data in case of hard drive failure. Data is only recoverable from backup. However, if you have a separate arrays for the OS and data. Meaning two arrays, you can swap ...

raid controller failure. Server is not able to initialize device. Workaround: 1: Turn off server 2: Take out Raid Controller from server > blow air on raid controller slot to remove dust. 3: Put it

...Chances are that either you had a drive failure or the metadata on your RAID volume (JBOD?) was corrupted. This is a common issue with these LSI-based PERC[5-6]i RAID controllers that Dell

failure during a power outage, the server lost power and would not come back up. (Wouldnt power on) Contractor checked and advised that the motherboard was fried, so had that replaced, next contractor